Please note: this questionnaire has not yet been checked by a professional. Treat the outcome as an example only.
Pulling electrical circuits
- Difficulty:
- Demanding
- Duration:
- 2 to 5 days, depending on the number of points
- Questions:
- 15
- 3D configurator:
- you see your job in 3D with every question
- Step-by-step plan:
- 16 steps

You plan your points and circuits, chase grooves or work in a hollow wall or surface-mounted, set the boxes and lay pre-wired conduit with the right wire size to every point. You also draw the single-line diagram and the position plan the inspector asks for.
Connecting sockets, switches and lamps, the consumer unit and the inspection itself are separate jobs. A new installation or an important extension must always be inspected before you use it.
Often combined with
Jobs that usually come just before or after this one.
3D configuratorFitting or renewing a consumer unitA new single-phase consumer unit with a main residual current device, 30 mA devices and breakers, following the AREI and ready for inspection.Demanding19 questions1 day of preparation, half a day to a full day for the changeover, plus the inspectionView this job
Connecting sockets, switches and light pointsSafely connecting sockets, switches, two-way circuits, lamps and an outdoor lamp with a motion sensor to cables that are already in place.Moderate18 questionsHalf a day to a full dayView this job
3D configuratorPreparing for the electrical inspection (AREI)Get your electrical installation ready for the inspection: diagrams, labels, a self-check, booking and what to do with the report.Easy17 questionsHalf a day to a day of preparation, plus the visitView this job
3D configuratorPlastering walls and ceilingsGypsum plaster by hand on brick, block or concrete, or repairing and smoothing old plaster: primer, rails, corner beads, ruling off and smoothing.Demanding18 questions1 to 3 days, plus 3 to 4 weeks of drying timeView this job
Fitting a suspended ceilingA new ceiling of plasterboard on metal profiles and hangers, with insulation, recessed spots or an access hatch if you want them.Moderate15 questions2 to 3 days for a room of 20 m²View this job